162 | Chapter 5: Managing Device Security
GS108T and GS110TP Smart Switch Software Administration Manual
The Profile Summary table shows the rules that are configured for the profile, as the following
table describes.
Field Description
Rule Type Identifies the action the rule takes, which is either Permit or Deny.
Service Type Displays the type of service to allow or prohibit from accessing the switch
management interface:
• SNMP
• HTTP
• HTTPS
Source IP Address Displays the IP Address of the client that may or may not originate
management traffic.
Mask Displays the subnet mask associated with the IP address.
Priority Displays the priority of the rule. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule
matches, action is performed and subsequent rules below are ignored.
Click Refresh to update the page with the most current information.
Access Rule Configuration
Use the Access Rule Configuration page to configure the rules about what systems can
access the GS108T or GS110TP Web interface and what protocols are allowed.
To access the Access Rule Configuration page, click Security Access, and then click the
Access Control Access Rule Configuration link.
To Next Page
Loading...
