NETGEAR GS110TP - ProSafe Gigabit Smart Switch

30 | Chapter 1: Getting Started
GS108T and GS110TP Smart Switch Software Administration Manual
Interface Naming Convention
The switch support physical and logical interfaces. Interfaces are identified by their type and
the interface number. The physical ports are gigabit interfaces and are numbered on the front
panel. You configure the logical interfaces by using the software. The following table
describes the naming convention for all interfaces available on the switch.
Interface Description Example
Physical The physical ports are gigabit Ethernet
interfaces and are numbered sequentially
starting from one.
g1, g2, g3
Link Aggregation Group (LAG) LAG interfaces are logical interfaces that are
only used for bridging functions.
l1, l2, l3
LAG1, LAG2
CPU Management Interface This is the internal switch interface responsible
for the switch base MAC address. This interface
is not configurable and is always listed in the
MAC Address Table.
c1