Chapter 7: Maintaining the System | 229
GS108T and GS110TP Smart Switch Software Administration Manual
3. To set the selected image as the active image, select the Active Image check box.
Note: After activating an image, you must perform a system reset of the
switch in order to run the new code.
4. To remove the selected image from permanent storage on the switch, select the Delete
Image check box. You cannot delete the active image.
5. Click Cancel to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.
6. Click Apply to apply the settings to the switch.
Dual Image Status
You can use the Dual Image Status page to view information about the system images on the
device.
To display the Dual Image Status page, click Maintenance > File Management Dual Image
Dual Image Status.
To Next Page
Loading...
