NETGEAR GS110TP - ProSafe Gigabit Smart Switch

Chapter 7: Maintaining the System | 221
GS108T and GS110TP Smart Switch Software Administration Manual
Factory Default
Use the Factory Default page to reset the system configuration to the factory default values.
Note: If you reset the switch to the default configuration, the IP address is
reset to 192.168.0.239, and the DHCP client is enabled. If you loose
network connectivity after you reset the switch to the factory
defaults, see Connecting the Switch to the Network on page 11 .
To access the Factory Defaults page, click Maintenance  Reset  Factory Default.
To reset the switch to the factory default settings:
1. Select the check box on the page.
2. Click Apply. The switch resets immediately.