Chapter 5: Managing Device Security | 179
GS108T and GS110TP Smart Switch Software Administration Manual
Protected Ports Membership
If a port is configured as protected, it does not forward traffic to any other protected port on
the switch, but it will forward traffic to unprotected ports. Use the Protected Ports Membership
page to configure the ports as protected or unprotected.
To display the Protected Ports Membership page, click the Security Traffic Control
Protected Ports link.
To configure protected ports:
1. Click the orange bar to display the available ports.
2. Click the box below each port to configure as a protected port. Protected ports are marked
with an X. No traffic forwarding is possible between two protected ports.
3. Click Refresh to refresh the page with the most current data from the switch.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take effect immediately.
To Next Page
Loading...
