Get Started
11
M4100 Series Switches
Confirm new password:********
Password Changed!
3. To change the management VLAN ID, type Y, and type a new VLAN ID.
Current Management VLAN ID: 1
Do you want to set new Management VLAN ID (Y/N/Q)?
You are prompted to set up the IP address of the switch.
4. Set up the IP address of the switch, either manually (type C) or through DHCP (type D):
Assigning an IPv4 address to your switch management
Current IPv4 Address Configuration
----------------------------------
Management VLAN ID: 1
IPv4 Address Assignment Mode: Manual
IPv4 Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Default Router IPv4: 0.0.0.0
Routing Mode: Enable
IPv4 address has been assigned manually. What do you want to do?
C - Change IPv4 address.
D - Assign IPv4 address for the switch using DHCP Mode(current
IPv4 address will be
lost).
N - Skip this option and go to the next question.
Q - Quit.
? - Help.
(C/D/N/Q/?)?
If the switch was already assigned an IP address and you do not want to change the IP
address again, type N.
ezconfig displays the current IP address and subnet mask. By default, the network DHCP
server assigns IP addresses automatically according to DHCP. However, you can
overwrite the DHCP client mode by assigning a fixed IP address here. Once a fixed IP
address is assigned, ezconfig automatically disables DHCP client mode and assigns the
static IP address to the management VLAN.
To Next Page
Loading...
Need help?
General
