NETGEAR M4100 Series Software Setup Manual

Get Started
12
M4100 Series Switches
5. To set up an IPv6 address for the management VLAN, type C to assign a new global IPv6
address, or type D to get an IP6 address from an IPv6 DHCP server, or type A to generate
the IPv6 address automatically.
Management VLAN ID: 1
IPv6 Address: fe80::6eb0:ceff:fef9:f6e3/64
IPv6 Current state: TENT
EUI64: Disabled
Routing Mode: Enable
IPv6 address has been assigned manually. What do you want to do?
C - Add IPv6 address.
D - Assign IPv6 address for the switch using DHCP Mode.
A - Assign IPv6 address for the switch using Auto Mode.
N - Skip this option and go to the next question.
Q - Quit.
? - Help.
(C/D/A/N/Q/?)
6. To enable the routing interface, type Y.
Do you want routing to be enabled (Y/N)?
7. Assign a switch name and location information.
Enter alphanumeric characters only. Characters such as # and $ are not supported. The
number of characters cannot exceed 31 characters.
Assigning System Name, System Location and System Contact to your
switch management
Current Configuration
--------------------------------
System Name:
System Location:
System Contact:
Do you want to assign switch name and location information?
(Y/N/Q)
Assigning SNTP server for time stamp to your switch management
Current Configuration

NETGEAR M4100 Series Specifications

General

Model	M4100 Series
Switch Type	Managed
Form Factor	Rack-mountable
Port Configuration	24 or 48 ports
Ethernet Ports	10/100/1000 Mbps
PoE Support	Available on some models (PoE and PoE+)
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
QoS	Yes
Stackable	Yes
Ports	24 or 48
Jumbo Frame Support	Yes
Security Features	ACL, 802.1X, RADIUS, TACACS+
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-20° to 70° C (-4° to 158° F)
Power Supply	Internal power supply