•
Gigabit transceiver modules:
- AGM734. SFP transceiver 1000BASE-T, SFP copper RJ-45 GBIC
- AXM765. SFP+ transceiver 10GBASE-T, SFP+ copper RJ-45 GBIC
Note: The AXM765 module is supported on switch models M4300-24XF and
M4300-48XF only.
•
Direct attach cables:
- AXC761. SFP+ 1m direct attach cable
- AXC763. SFP+ 3m direct attach cable
- AXC765. SFP+ 5m direct attach cable
- AXC767. SFP+ 7m direct attach cable
- AXC7610. SFP+ 10m direct attach cable
- AXC7615. SFP+ 15m direct attach cable
- AXC7620. SFP+ 20m direct attach cable
For more information about NETGEAR SFP and SFP+ transceiver modules and cables,
visit netgear.com/business/products/switches/modules-accessories. If purchased,
transceiver modules and cables are shipped separately form the switch.
USB port
The switch provides one USB 2.0 port that lets you upgrade firmware from a disk, back
up the configuration to a storage device, and allow for the collection of a memory dump
for debugging purposes.
A device that you attach to the USB port must comply with the following requirements:
•
The USB device must support USB 2.0.
•
The USB device must support the FAT32 or VFAT file type. The NTFS file type is not
supported.
Because of hardware limitations, the write speed to and read speed from a USB device
is about 1 Mbps.
Note: In a stack, only the switch that functions as the master can detect and manage
an attached USB device.
Hardware Installation Guide42Hardware Overview
M4300 Intelligent Edge Series Fully Managed Stackable Switches
To Next Page
Loading...
