NETGEAR M4300-12X12F - Install a Single Half-Width Switch in a Rack

The following figure shows model M4300-52G-POE+. However, you install the other
full-width models in the same manner.
Install a single half-width switch in a rack
To install a single half-width switch in single rack space, you need the 19-inch rack-mount
kit supplied with the switch. The figures in the following procedure shows model
M4300-24X. However, you install the other half-width models in the same manner.
Hardware Installation Guide52Installation
M4300 Intelligent Edge Series Fully Managed Stackable Switches