3
Installation
This chapter describes the installation procedures for the switch. Switch installation
involves the steps described in the following sections:
• Step 1: Prepare the site
• Step 2: Protect against electrostatic discharge
• Step 3: Unpack the switch
• Step 4: Install the switch
• Optional Step 5: Install SFP transceiver modules
• Optional Step 6: Install a power supply unit
• Optional Step 7: Connect a redundant power supply to model M4300-52G-POE+
• Step 8: Check the installation
• Step 9: Apply AC power and check the LEDs
• Optional Step 10: Connect a console to the switch
47
To Next Page
Loading...
