NETGEAR M4300-12X12F - Power Supply Units

The switch reboots.
Power supply units
The following table describes the power supply units (PSUs) and options.
For models M4300-16X, M4300-28G-POE+, and M4300-52G-POE+, the PSU that is
installed depends on the product ordered. For models that can support two PSUs, you
can order a second PSU as an option.
Table 5. Supported PSUs
RPS SupportPower RedundancyPossible PSU ConfigurationsSwitch Model
1x APS299W
1x APS600W
M4300-16X
1x APS250WM4300-8X8F
1x APS250WM4300-12X12F
1x APS250W
2x APS250W
M4300-24X24F
1x APS150W
2x APS150W
M4300-28G
1x APS150W
2x APS150W
M4300-52G
N+1 redundancy is
supported for this
model
1x APS550W
2x APS550W
1x APS1000W
2x APS1000W
1x APS550W + 1x APS1000W (see
Note)
M4300-28G-POE+
An RPS is supported
for this model
N+1 redundancy is
supported for this
model
1x APS550W
2x APS550W
1x APS1000W
2x APS1000W
1x APS550W + 1x APS1000W (see
Note)
M4300-52G-POE+
1xAPS250WM4300-24X
1xAPS250WM4300-24XF
Hardware Installation Guide44Hardware Overview
M4300 Intelligent Edge Series Fully Managed Stackable Switches