NETGEAR M4300 Intelligent Edge Series User Manual

Out-of-band 1G Ethernet port
The switch provides one out-of-band (OOB) 1000BASE-T RJ-45 Ethernet port that lets
you access the switch over its local browser interface or over a Telnet or SSH session.
Mini USB console port
The switch provides one mini USB console port for console access only. The product
package includes one USB console cable with one mini B connector and one type A
connector. You can use this cable to connect the mini USB console port on the switch
to a USB port on a VT100-compatible terminal or a Windows-based computer that runs
VT100 terminal emulation software.
Note: For you to be able to use the mini USB port and access the switch from a
Windows-based computer that runs VT100 terminal emulation software, you must install
the USB driver on the computer. To download the VT100 terminal emulation software
and Windows USB driver, visit https://www.netgear.com/support/, enter your model
number in the search box, and click the Downloads button on the product page.
RJ-45 RS232 console port
The switch provides one RJ-45 RS232 console port for console access only. This serial
port is configured for 115200 baud, eight data bits, one stop bit, and no parity.
The switch package includes one console cable with one DB9 connector and one RJ-45
connector. You can use this cable to connect the RJ-45 RS232 console port on the switch
to a DB9 port on a VT100-compatible terminal or a Windows-based computer that runs
VT100 terminal emulation software.
RPS interface
The redundant power supply (RPS) interface on model M4300-52G-POE+ provides a
receptacle for an RPS cable such as the NETGEAR DC Connection Cable Model
RPSC5412.
Reset button
The switch provides a Reset button on the front panel so that you can reboot the switch.
Save the configuration before you press the Reset button.
To reboot the switch:
1. Insert a device such as a straightened paper clip into the opening.
2.
Press the recessed Reset button for about three seconds.
Hardware Installation Guide43Hardware Overview
M4300 Intelligent Edge Series Fully Managed Stackable Switches

NETGEAR M4300 Intelligent Edge Series Specifications

General

Switch Type	Managed
Form Factor	Rack-mountable
Layer 3 Features	Static routing, RIP, OSPF, VRRP
Model	NETGEAR M4300 Intelligent Edge Series
Ports	Varies by model
PoE	Available on some models
Stacking	Yes
Redundancy	Redundant power supplies (on some models)
Management	Web-based, CLI, SNMP
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
Layer 2 Features	VLAN, STP, RSTP, MSTP
Security Features	ACL, 802.1X
Dimensions	Varies by model (see documentation)
Weight	Varies by model (see documentation)
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Power Supply	Internal
Warranty	Lifetime