EasyManuals Logo

NETGEAR M4300 Intelligent Edge Series User Manual

NETGEAR M4300 Intelligent Edge Series
69 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Additional troubleshooting suggestions
If the suggestions in the troubleshooting chart do not resolve the problem, see the
following troubleshooting suggestions:
Network adapter cards. Make sure that the network adapters that are installed in
the computers are in working condition and the software driver was installed.
Configuration. If problems occur after you alter the network configuration, restore
the original connections and determine the problem by implementing the new
changes one step at a time. Make sure that cable distances, repeater limits, and
other physical aspects of the installation do not exceed the Ethernet limitations.
Switch integrity. If necessary, verify the integrity of the switch by resetting it. To
reset the switch, disconnect the AC power from the switch and then reconnect the
AC power. If the problem continues, contact NETGEAR Technical Support. For more
information, visit the support website at support.netgear.com.
Autonegotiation. The RJ-45 ports negotiate the correct duplex mode, speed, and
flow control if the device at the other end of the link supports autonegotiation. If the
device does not support autonegotiation, the switch determines only the speed
correctly, and the duplex mode defaults to half-duplex.
The Gigabit Ethernet ports negotiate speed, duplex mode, and flow control if the
attached device supports autonegotiation.
Hardware Installation Guide69Maintenance and
Troubleshooting
M4300 Intelligent Edge Series Fully Managed Stackable Switches

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4300 Intelligent Edge Series and is the answer not in the manual?

NETGEAR M4300 Intelligent Edge Series Specifications

General IconGeneral
Switch TypeManaged
Form FactorRack-mountable
Layer 3 FeaturesStatic routing, RIP, OSPF, VRRP
ModelNETGEAR M4300 Intelligent Edge Series
PortsVaries by model
PoEAvailable on some models
StackingYes
RedundancyRedundant power supplies (on some models)
ManagementWeb-based, CLI, SNMP
Switching CapacityVaries by model
Forwarding RateVaries by model
Jumbo Frame SupportYes
Layer 2 FeaturesVLAN, STP, RSTP, MSTP
Security FeaturesACL, 802.1X
DimensionsVaries by model (see documentation)
WeightVaries by model (see documentation)
Operating Temperature0° to 50° C (32° to 122° F)
Storage Temperature-4°F to 158°F (-20°C to 70°C)
Power SupplyInternal
WarrantyLifetime

Related product manuals