NETGEAR M4300 Intelligent Edge Series User Manual

The following figure shows model M4300-48X. However, you install SFP transceiver
modules in the SFP+ ports of the 1G models with 10G uplinks or the 10G models
with RJ45/SFP+ combo ports in the same manner.
Optional Step 6: Install a power supply unit
The supported power supply unit (PSU) or PSUs depend on the switch model. For more
information, see Power supply units on page 44.
The PSU for model M4300-16X might be in the product package, in which case you
must install it in the power module bay.
The following full-width models provide a second power module bay in which you can
install an optional second PSU:
•
M4300-24X24F, M4300-48X, and M4300-48XF
•
M4300-28G and M4300-28G-POE+
•
M4300-52G and M4300-52G-POE+
For these models, the PSU that is shipped with the product is installed in the power
supply bay on the left, which is marked PSU1. You can install the second PSU in the
power supply bay on the right, which is marked PSU2. The switch can continue to operate
while you install a second PSU.
To install a PSU:
1.
Pull out the cover plate from the power module bay. For models with two power
modules bays, the PSU that is shipped with the product is installed in the left power
supply bay. The second power supply bay is the one on the right.
Hardware Installation Guide58Installation
M4300 Intelligent Edge Series Fully Managed Stackable Switches

NETGEAR M4300 Intelligent Edge Series Specifications

General

Switch Type	Managed
Form Factor	Rack-mountable
Layer 3 Features	Static routing, RIP, OSPF, VRRP
Model	NETGEAR M4300 Intelligent Edge Series
Ports	Varies by model
PoE	Available on some models
Stacking	Yes
Redundancy	Redundant power supplies (on some models)
Management	Web-based, CLI, SNMP
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
Layer 2 Features	VLAN, STP, RSTP, MSTP
Security Features	ACL, 802.1X
Dimensions	Varies by model (see documentation)
Weight	Varies by model (see documentation)
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Power Supply	Internal
Warranty	Lifetime