Configure Switching
129
Smart Managed Pro Switches MS510TX and MS510TXPP
View STP Statistics
You can view information about the number and type of bridge protocol data units (BPDUs)
transmitted and received on each port.
To view Spanning Tree statistics:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > STP > Advanced > STP Statistics.
The STP Statistics page displays.
6. Select which type of interfaces display onscreen:
• To display physical ports only, click the PORTS link.
• To display LAGs only, click the LAGS link.
• To display both physical ports and LAGs, click the All link.
7. To refresh the page with the latest information about the switch, click the Refresh button.
The following table describes the information available about the STP Statistics page.
Configure Multicast
Multicast IP traffic is traffic that is destined to a host group. Host groups for IPv4 multicast are
identified by class D addresses, which range from 224.0.0.0 to 239.255.255.255. Host
groups for IPv6 multicast are identified by the prefix ff00::/8.
Table 33. STP Statistics
Field Description
Interface The physical port or LAG.
STP BPDUs Received The number of STP BPDUs received at the port or LAG.
STP BPDUs Transmitted The number of STP BPDUs transmitted from the port or LAG.
To Next Page
