Maintain the Switch and Perform Troubleshooting
313
Smart Managed Pro Switches MS510TX and MS510TXPP
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > Reset > Factory Default.
The Factory Default page displays.
6. Select the check box.
7. Click the Apply button.
A confirmation pop-up window opens.
8. Click the Yes button to confirm.
All configuration settings are reset to their factory default values. All changes that you
made are lost, even if you saved the configuration.
Export a File From the Switch
The switch supports system file exports from the switch to a remote system by using either
TFTP, HTTP or USB.
The Maintenance > Export menu contains links to the features described in the following
sections.
• Export a File to the TFTP Server on page 313
• HTTP File Export on page 315
• Export a File From the Switch to a USB Device on page 316
Export a File to the TFTP Server
Use the TFTP File Export page to export configuration (ASCII), log (ASCII), and image
(binary) files from the switch to a TFTP server on the network.
To export a file from the switch to the TFTP server:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
To Next Page
