Manage Device Security
239
Smart Managed Pro Switches MS510TX and MS510TXPP
Activate or Deactivate an Access Control Profile and View the Profile
Summary
After you set up an access profile and add access rules to the profile, you must activate the
profile to be able to use it. (You do not need to activate the profile, but if you do not, you
cannot use it.)
If you want to make a change to an access rule for an access control profile, you must first
deactivate the access control profile.
To activate or deactivate an access profile and view the profile summary:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Access > Access Control > Access Profile Configuration.
The Access Profile Configuration page displays. The page also shows the Profile
Summary section.
6. Take one of the following actions:
• To activate the access profile, select the Activate Profile radio button.
• To deactivate the access profile, select the Deactivate Profile radio button.
7. Click the Apply button.
Your settings are saved.
8. To refresh the page with the latest information about the switch, click the Refresh button.
The following table describes the nonconfigurable data that is displayed.
Table 56. Access profile configuration profile summary
Field Description
Rule Type The action performed when the rules are matched.
Service Type The service type chosen. The policy is restricted by the service type chosen.
Source IP Address The source IP address of the client originating the management traffic.
To Next Page
