Nighthawk AX8 8-Stream AX6000 WiFi Router
UseVPNtoAccessYourNetwork 126 User Manual
Set Up a VPN Connection
A virtual private network (VPN) lets you use the Internet to securely access your network when
you aren’t home.
This type of VPN access is called a client-to-gateway tunnel. The computer is the client, and the
router is the gateway. To use the VPN feature, you must log in to the router and enable VPN, and
you must install and run VPN client software on the computer.
VPN uses DDNS or a static IP address to connect with your router.
To use a DDNS service, register for an account with a host name (sometimes called a domain
name). You use the host name to access your network. The router supports these accounts:
NETGEAR, No-IP, and Dyn.
If your Internet service provider (ISP) assigned a static WAN IP address (such as 50.196.x.x or
10.x.x.x) that never changes to your Internet account, the VPN can use that IP address to connect
to your home network.
Specify VPN Service in the Router
You must specify the VPN service settings in the router before you can use a VPN connection.
To specify the VPN service:
1. Launch a web browser from a computer or mobile device that is connected to the router
network.
2. Enter the router user name and password.
The user name is admin. The password is the one that you specified the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
3. Select ADVANCED > Advanced Setup > VPN Service. The VPN page displays.
4. Select the Enable VPN Service check box.
By default, the VPN uses the UDP service type and uses port 12974. If you want to customize
the service type and port, we recommend that you change these settings before you install
the OpenVPN software.
5. To change the service type, scroll down and select the TCP radio button.
6. To change the port, scroll down to the Service Port field, and type the port number that you
want to use.
7. Click the Apply button.
To Next Page
Loading...
Need help?
General
