6. From the Internet Service Provider menu, select PPTP or L2TP as the encapsulation method.
7. In the Login field, enter the login name that your ISP gave you.
This login name is often an email address.
8. In the Password field, type the password that you use to log in to your Internet service.
9. From the Connection Mode menu, select Always On, Dial on Demand, or Manually Connect.
10. To change the number of minutes until the Internet login times out, in the Idle Timeout (In minutes)
field, type the number of minutes.
This is how long the router keeps the Internet connection active when no one on the network is using
the Internet connection. A value of 0 (zero) means never log out.
11. If your ISP gave you fixed IP addresses and a connection ID or name, type them in the My IP Address,
Subnet Mask, Server Address, Gateway IP Address, and Connection ID/Name fields.
If your ISP did not give you IP addresses, a connection ID, or name, leave these fields blank.The
connection ID or name applies to a PPTP service only.
12. Select a Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP.Your ISP uses DHCP to assign your DNS servers.Your ISP
automatically assigns this address.
• Use These DNS Servers. If you know that your ISP requires specific servers, select this option.
Enter the IP address of your ISP’s primary DNS server. If a secondary DNS server address is
available, enter it also.
Specify Your Internet Settings
29
Nighthawk AC1900 Smart WiFi Router Model R6900P
To Next Page
Loading...
Need help?
General
