Control Access to the Internet
31
VDSL Voice Gateway
8. If your outgoing email server requires authentication, select the My Mail Server requires
authentication check box.
a. In the User Name field, type the user name for the outgoing email server.
b. In the Password field, type the password for the outgoing email server.
9. To send alerts when someone attempts to visit a blocked site, select the Send Alerts
Immediately check box.
10. To send logs based on a schedule, specify these settings:
• From Send logs according to this schedule drop-down list, select the schedule
type.
• From the Day drop-down list, select the day.
• From the Time drop-down list, select the time and select the am or pm radio button.
11. Click the Apply button.
Your settings are saved.
Logs are sent according to the schedule that you set. If the log fills up before the specified
time, it is sent. After the log is sent, it is cleared from the gateway memory. If the gateway
cannot email the log and the log buffer fills up, the gateway overwrites the log.
Outbound Firewall Rules
You can add firewall rules to block or allow specific traffic. For information about inbound
rules, see
Set Up a Custom Port Forwarding Service on page 35.
Note: This feature is for advanced administrators only. Incorrect
configuration causes serious problems.
By default your gateway blocks any inbound traffic from the Internet to your computers
except for replies to your outbound traffic. You might need to create exceptions to this rule to
allow remote computers to access a server on your local network or to allow certain
applications and games to work correctly. Your gateway provides firewall rules for creating
these exceptions.
Authorized communications are established according to inbound and outbound rules.You
can create custom rules to further restrict the outbound communications or more widely open
the inbound communications.
Add a Custom Service
To add a custom service:
1. Launch a web browser from a computer or wireless device that is connected to the
network.
2. Type http://routerlogin.net or http://10.0.0.2.
To Next Page
Loading...
Need help?
General