Super G Wireless Router WGT624 v4 User Manual
Configuring Internet Connectivity 1-7
v1.0, July 2008
Table 1-1. Basic Settings screen fields
Settings Description
Does Your ISP Require a Login? • Yes
•No
These fields
appear only if no
login is required.
Internet Service Provider • PPTP (Point to Point Tunneling Protocol). This is used
primarily in Austrian DSL services.
• Telstra Bigpond. This setting is only for older cable modem
service accounts that still require a Bigpond Login utility.
Telstra has discontinued this type of account. Those with
Telstra DSL accounts and newer cable modem accounts
should select No for Does Your Internet Connection
Require A Login?.
• Other. This is the default setting. It is for PPPoE (Point to
Point Protocol over Ethernet), the protocol used by most
DSL services worldwide.
Account Name
(If required)
Enter the account name provided by your ISP. This might also
be called the host name.
Domain Name
(If required)
Enter the domain name provided by your ISP.
These fields
appear only if
your ISP
requires a login.
Login The login name provided by your ISP. This is often an e-mail
address.
Password The password that you use to log ISP.
Service Name If your ISP provided a Service Name, enter it here.
Connection Mode Specify when the router will connect to and disconnect from
the Internet.
• Always On. The router logs in to the Internet immediately
after booting and never disconnects.
• Dial on Demand. The router logs in only when outgoing
traffic is present and logs out after the idle time-out.
• Manually Connect. The router logs in or logs out only when
you click Connect or Disconnect in the Router Status
screen.
Idle Timeout (In minutes) If you want to change the Internet login time-out, enter a new
value in minutes. This determines how long the wireless router
keeps the Internet connection active after there is no Internet
activity from the LAN. Entering an Idle Timeout value of 0
(zero) means never log out.
To Next Page
Loading...
Need help?
General
