NETGEAR WGT624 v4 User Manual

Super G Wireless Router WGT624 v4 User Manual
A-2 Technical Specifications and Default Configuration
v1.0, July 2008
Default Configuration Settings
You can use the reset button located on the back of your WGT624 v4 wireless router to reset all
settings to their factory defaults. This is called a hard reset. To perform a hard reset, push and hold
the reset button for 3 seconds. Your wireless router will return to the factory configuration settings
shown in the table below.
Interface Specifications
LAN: 10BASE-T or 100BASE-TX, RJ-45
WAN: 10BASE-T or 100BASE-TX, RJ-45
Wireless
Radio Data Rates 1, 2, 5.5, 6, 9, 12, 18, 24, 36, 48, 54, and 108 Mbps
Auto Rate Sensing
Frequency 2.4-2.5 GHz
Data Encoding: Direct Sequence Spread Spectrum (DSSS) and Orthogonal
Frequency Division Multiplexing (OFDM)
Maximum Computers Per Wireless
Network:
Limited by the amount of wireless network traffic generated by
each node. Typically 30-70 nodes.
Operating Frequency Ranges: 2.412~2.462 GHz (US)
2.412~2.472 GHz (Japan)
2.412~2.472 GHz (Europe ETSI)
Encryption: 40-bit (also called 64-bit), 128-bit WEP data encryption,
WPA-PSK(TKIP), and WPA2-PSK(AES)
Table A-1. Default Configuration Settings
Feature Default Behavior
Smart Wizard Disabled
Router Login
Router login URL http://www. routerlogin.net or http://www.routerlogin.com
User name (case sensitive) admin
Password (case sensitive) password
Internet Connection
WAN MAC address Use default hardware address
MTU Size 1500

NETGEAR WGT624 v4 Specifications

General

Wireless Standard	802.11g
Frequency Band	2.4 GHz
LAN Ports	4 x 10/100 Mbps
WAN Port	1 x 10/100 Mbps
Security	WEP, WPA, WPA2
Wireless Data Rates	Up to 54 Mbps
VPN Pass-through	Yes
Antenna	2 x external
Interface	Ethernet
Firewall	NAT, SPI
Weight	0.66 lbs