Super G Wireless Router WGT624 v4 User Manual
4-6 Maintenance
v1.0, July 2008
Erasing the Configuration
You can restore the router to the factory default settings with the Erase function. After an erase, the
router’s password will be password, the LAN IP address will be 192.168.1.1, and the router’s
DHCP client will be enabled.
• To erase the configuration, click Erase on the Backup Settings screen.
• To restore the factory default configuration settings without knowing the login password or IP
address, use the Restore Factory Settings button on the rear panel of the router. See “Restoring
the Default Configuration and Password” on page 6-7.
Changing the Administrator Password
The default password for the router is password. NETGEAR recommends that you change this
password to a more secure password.
To change the password:
1. From the router’s main menu, below the Maintenance heading, select Set Password.
2. To change the password, enter the old password, and then enter the new password twice.
3. Click Apply.
Figure 4-5
To Next Page
Loading...
Need help?
General
