NETGEAR WGT624 v4 User Manual

Super G Wireless Router WGT624 v4 User Manual
Technical Specifications and Default Configuration A-3
v1.0, July 2008
Local Network
Router LAN IP address (aka gateway IP
address)
192.168.1.1
Router subnet 255.255.255.0
DHCP server Enabled
Time zone GMT
Time zone adjusted for Daylight Savings
time
Disabled
Firewall
Inbound (communications coming in from
the Internet)
Disabled (bars all unsolicited requests except for traffic
on port 80, the http port)
Outbound (communications going out to
the Internet)
Enabled (all)
Wireless
Wireless communication Enabled
SSID name NETGEAR
Security Disabled
Broadcast SSID Enabled
Transmission speed Auto
a
Country/region United States (in North America, otherwise varies by
region)
RF channel 6 i
n North America, otherwise varies by region
Operating Mode Auto 108 Mbps in North America & Europe, otherwise
varies by region
Data rate Best
Output power Full
a. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead, lower actual data throughput rate.
Table A-1. Default Configuration Settings (continued)
Feature Default Behavior

NETGEAR WGT624 v4 Specifications

General

Wireless Standard	802.11g
Frequency Band	2.4 GHz
LAN Ports	4 x 10/100 Mbps
WAN Port	1 x 10/100 Mbps
Security	WEP, WPA, WPA2
Wireless Data Rates	Up to 54 Mbps
VPN Pass-through	Yes
Antenna	2 x external
Interface	Ethernet
Firewall	NAT, SPI
Weight	0.66 lbs