Super G Wireless Router WGT624 v4 User Manual
Content Filtering 3-7
v1.0, July 2008
2. Specify whether or not you want alters or logs automatically sent to the specified e-mail
address:
• Send Alert Immediately. Select this check box to receive immediate notification of
attempted access to a blocked site.
• Send Logs According to this Schedule. Specifies how often to send the logs: None,
Hourly, Daily, Weekly, or When Full.
– None. Logs will not be sent. If you turned on e-mail notification, the alert will be sent
but not the log.
– Day for sending log. The day of the week to send the log. Relevant when the log is
sent weekly or daily.
– Time for sending log. The time of day to send the log. Relevant when the log is sent
daily or weekly.
If the Weekly, Daily or Hourly option is selected and the log fills up before the specified
period, the log is automatically e-mailed to the specified e-mail address. After the log is sent, it
is cleared from the router’s memory. If the router cannot e-mail the log file, the log buffer
might fill up. In this case, the router overwrites the log and discards its contents.
3. The wireless router uses Network Time Protocol (NTP) to obtain the current time and date
from one of several network time servers on the Internet. In order to localize the time for your
log entries, you must specify your time zone:
• Time Zone. Select your local time zone. This setting will be used for the blocking
schedule and for time-stamping log entries.
• Automatically Adjust for Daylight Savings Time. Select this check box to automatically
adjust for daylight savings time.
4. Click Apply to save your settings.
To Next Page
Loading...
Need help?
General
