EasyManuals Logo

NETGEAR WGT624 v4 User Manual

NETGEAR WGT624 v4
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Super G Wireless Router WGT624 v4 User Manual
Advanced Configuration 5-25
v1.0, July 2008
To configure a WGT624 v4 wireless router as a repeater unit:
1. If you are using the same model of wireless router for both the base station and repeaters, you
must change the LAN IP address for each repeater to a different IP address in the same subnet
(see “Using LAN IP Setup Options” on page 5-10).
2. Check the Wireless Settings screen, and verify that the wireless settings match the base unit
exactly. The wireless security option must be set to WEP or None.
3. In the Wireless Repeating Function screen, select the Enable Wireless Repeater Mode radio
button.
This IP address must be in the same subnet as the base station but different from the LAN IP of
the base station.
4. Fill in the Base Station MAC Address field.
5. Click Apply to save your changes.
6. Verify connectivity across the LANs.
A computer on any wireless or wired LAN segment of the wireless router should be able to
connect to the Internet or share files and printers with any other wireless or wired computer or
server connected to the other AP.
Note: Failing to change the LAN IP address will cause an IP address conflict in the
network because the factory default LAN IP is the same for both units.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR WGT624 v4 and is the answer not in the manual?

NETGEAR WGT624 v4 Specifications

General IconGeneral
Wireless Standard802.11g
Frequency Band2.4 GHz
LAN Ports4 x 10/100 Mbps
WAN Port1 x 10/100 Mbps
SecurityWEP, WPA, WPA2
Wireless Data RatesUp to 54 Mbps
VPN Pass-throughYes
Antenna2 x external
InterfaceEthernet
FirewallNAT, SPI
Weight0.66 lbs

Related product manuals