NETGEAR WN802T User Manual

NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Installation and Configuration 2-13
v1.0, September 2008
Logging in to the NETGEAR Wireless-N Access Point
The WN802T v2 is set, by default, with the IP address of 192.168.0.233 with DHCP disabled.
If DHCP is enabled, you can connect to the WN802T v2 after the DHCP server on your network
assigns it a new IP address:
Reserve an IP address (based on the WN802T v2’s MAC address) on the DHCP server. That way,
if your router is deployed across several segments, you can configure the wireless access point
with a static IP address which you can always use to log in to make future configuration changes.
To log in using the default IP address:
1. Open a Web browser such as Mozilla Firefox or Internet Explorer.
Note: If logging in using the default IP address, the computer you are using to connect to
the WN802T v2 should be configured with an IP address that starts with
192.168.0.x and a subnet mask of 255.255.255.0.
Figure 2-7 Enable DHCP client

NETGEAR WN802T Specifications

General

Maximum data transfer rate	300 Mbit/s
MAC address filtering	Yes
Minimum system requirements	-Internet Explorer 6.0; -4 GHz 802.11n / 2.4 GHz 802.11 b/ g;
Compatible operating systems	Microsoft Windows 98, Me, 2000, XP, Mac OS, UNIX, / Linux

Weight and Dimensions

Weight	560 g
Dimensions (WxDxH)	225.5 x 172 x 39 mm