NETGEAR WN802T User Manual

NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Management 4-7
v1.0, September 2008
The factory settings are restored and the access point reboots. This takes about a minute. A list of
the factory default settings can be found in the appendix in.Table A-1.
Viewing the Available Wireless Stations List
The Available Wireless Station list contains a table of all IP devices associated with this wireless
access point network defined by its wireless network name (SSID).
To view the list of available wireless stations:
1. From the Configuration menu of the browser interface, select Monitoring and then Wireless
Stations. The Available Wireless Stations list displays (see Figure 4-6).
2. Click Refresh to update the list and force the wireless access point to look for associated
devices.
• For each device, the Available Wireless Stations table shows data such as the MAC
address, the BSSID, and the SSID (not populated).
Warning: Do not try to go online, turn off the Access Point, shut down the
computer or do anything else to the Access Point until it finishes
restarting. When the PWR light turns green, wait a few more seconds
before doing anything with the Access Point.
Figure 4-6 Available wireless stations list

NETGEAR WN802T Specifications

General

Maximum data transfer rate	300 Mbit/s
MAC address filtering	Yes
Minimum system requirements	-Internet Explorer 6.0; -4 GHz 802.11n / 2.4 GHz 802.11 b/ g;
Compatible operating systems	Microsoft Windows 98, Me, 2000, XP, Mac OS, UNIX, / Linux

Weight and Dimensions

Weight	560 g
Dimensions (WxDxH)	225.5 x 172 x 39 mm