NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
4-6 Management
v1.0, September 2008
To reboot the wireless access point from the user interface:
1. From the main menu of the browser interface, select Maintenance > Reset and then Reboot
AP on the side menu. The Reboot AP screen displays as follows:.
2. Select the Yes radio button next to the Reboot option, and then click Apply.
To erase the current settings and reset the wireless access point to the original factory default
settings:
1. In Step 1 of the previous section, select Restore Defaults from the side menu (see Figure 4-
5).
2. Select the Yes radio button next to the Restore to factory default settings option.
3. Click Apply.
Figure 4-5 Reboot the AP
Warning: Do not try to go online, turn off the Access Point, shut down the
computer or do anything else to the Access Point until it finishes
rebooting. When the power light turns green, wait a few more
seconds before doing anything with the Access Point.
To Next Page
Loading...
