NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Troubleshooting and Help 6-5
v1.0, September 2008
• Reboot: When pressed and released quickly, the WN802T v2 will reboot (restart).
• Reset to Factory Defaults: This button can also be used to clear ALL data and restore ALL
settings to the factory default values. These settings are shown in Appendix A, “Default
Settings and Technical Specifications”.
To clear all data and restore the factory default values:
1. Power off the WN802T v2 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for
at least five seconds—or until the power light changes from blinking green to amber.
3. Release the Reset button.
The factory default configuration has now been restored, and the WN802T v2 is ready for use.
Online Help
For more help, click Support on the main menu when the access point is connected to the internet
(see Figure 6-2):
• Click the Documentation link under the Support menu to view the documentation for the
WN802Tv2 wireless access point online.
• Click the Knowledge Base link to access NETGEAR’s knowledge base articles online.
Figure 6-2 Netgear online support links
To Next Page
Loading...
Need help?
General
Weight and Dimensions
