NETGEAR WN802T User Manual

Default Settings and Technical Specifications A-1
v1.0, September 2008
Appendix A
Default Settings and Technical Specifications
This appendix provides the factory default settings and technical specifications for the NETGEAR
Wireless-N Access Point WN802T v2.
Factory Default Settings
You can use the Reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
• To perform a hard reset, push and hold the Reset button for approximately 5 seconds (until the
Power LED changes from blinking green to solid amber). Your device will return to the
factory configuration settings shown in Table A-1.
• Pressing the Reset button for a shorter period of time will simply cause your device to reboot.
Table A-1. Access Point Default Configuration Settings
Feature Description
AP Login
User Login URL 192.168.0.233
User Name (case sensitive) admin
Login Password (case sensitive) password
Ethernet Connection
Ethernet MAC Address See rear label.
Access Point Mode On
Port Speed 10/100/1000 Mbps
Local Network (LAN)
Lan IP 192.168.0.233
Subnet Mask 255.255.255.0
Gateway Address 192.168.0.1

NETGEAR WN802T Specifications

General

Maximum data transfer rate	300 Mbit/s
MAC address filtering	Yes
Minimum system requirements	-Internet Explorer 6.0; -4 GHz 802.11n / 2.4 GHz 802.11 b/ g;
Compatible operating systems	Microsoft Windows 98, Me, 2000, XP, Mac OS, UNIX, / Linux

Weight and Dimensions

Weight	560 g
Dimensions (WxDxH)	225.5 x 172 x 39 mm