NETGEAR WN802T User Manual

NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Management 4-9
v1.0, September 2008
Viewing Network Traffic Statistics
The Statistics screen displays both wired and wireless interface network traffic.
Current IP Settings
IP Address The IP address of the wireless access point.
Subnet Mask The subnet mask for the wireless access point.
Default Gateway The default gateway for the wireless access point communication.
DHCP Client Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
Current Wireless Settings for 802.11b/bg/ng
Access Point Mode Identifies the operating mode of the WN802T v2: Standard Access Point,
Point to Multi-point bridge, or Repeater without wireless association
Channel/Frequency Identifies the channel the wireless port is using. 11 is the default channel
setting. (Channel frequencies used on each channel can be found in
“Wireless Communications”; a link to this article is in Appendix B,
“Related Documents”.).
Figure 4-7 General system information
Table 4-1. System Information fields (continued)
Field Description

NETGEAR WN802T Specifications

General

Maximum data transfer rate	300 Mbit/s
MAC address filtering	Yes
Minimum system requirements	-Internet Explorer 6.0; -4 GHz 802.11n / 2.4 GHz 802.11 b/ g;
Compatible operating systems	Microsoft Windows 98, Me, 2000, XP, Mac OS, UNIX, / Linux

Weight and Dimensions

Weight	560 g
Dimensions (WxDxH)	225.5 x 172 x 39 mm