NETGEAR WN802T - Page 95

NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Index-7
v1.0, September 2008
U
upgrade
firmware 4-3
user name
default 2-3, 2-11, 2-14
users
maximum 1-1
W
warranty 1-3
WEP 3-1
configure 3-6
wireless
connection, lose 3-15
connectivity, test 2-11, 2-12
wireless access by MAC address
restricting 3-15
wireless bridge
different configurations 5-1
multi-point 5-1
multi-point, configure 5-1
repeater without client association 5-1
security profile 5-1
standard access point mode 5-1
wireless bridging
enable 5-2
wireless client
roaming 1-1
security separation 3-5 to 3-15
wireless coverage area. See range
wireless mode 2-8
default 2-8
wireless network name 2-8
default 3-2
wireless security options 3-1
wireless settings
advanced 4-11
aggregation length 4-12
AMPDU 4-12
basic 2-7
beacon interval 4-11
broadcast wireless network name 2-8
channel wdth 2-9
DTIM interval 4-12
fragmentation length 4-11
guard interval 2-9
MCS index/data rate 2-9
output power 2-9
preamble type 4-12
RIFS 4-12
RTS threshold 4-11
turn radio on 2-8
wireless mode 2-8
wireless network name (SSID) 2-8
wireless stations
available 3-16
trusted 3-16
Wireless-N Access Point
deploy 2-12
See also WN802Tv2
WMM
see QoS
WMM power save
configure 2-11
WN802T v2
ethernet setup 2-2
password, default 4-1
WPA
client software support 3-3
dynamic per frame rekeying 3-2
preshared key passphrase 3-4
WPA with RADIUS 3-3
configuration of 3-8
configure 3-8
restrictions 3-8
WPA+WPA2 with RADIUS 3-3
configure 3-11
WPA/WPA2
support 1-2
use restrictions 3-3, 3-11
WPA/WPA-PSK
strong data security 3-2
WPA2
restrictions 3-10
WPA2 with RADIUS 3-3
configure 3-10