59
Peel off sensor can be used to sense peel off the printed label. You
can choose the way to enable the mode of peel off sensor work or
disable it.
To set Select Peel Off Sensor:
1. Enter ‘Main menu’, and follow 3 steps below.
2.Press
for “Enable”. The default setting
is 2.
4. Press
to save the setting and return to the
Initial State.
The LFA (Label Feed Adjustment) adjusts the print position of a label.
It is independent of the LFS number and can range from 0 to 40; 20
being the default value. The higher the number the lower things will
print on the label; the lower the number the higher things will print.
To set the Label Feed Adjustment:
1. Enter ‘Main menu’, and follow 3 steps below.
2. Press
.
3. Change the LFA number and press
; as you type
the number it will appear in the Total Price Display.
4. Press
.
5. You are back in the Initial State.
You may need to test print 2 or three labels to notice the change in
adjustment. Additionally, you may need to repeat this procedure to
get your desired alignment. Note:
there is no way to individually align
To Next Page
Loading...
General