MT 48 | 30
Advanced settings
Output levels
The analog outputs can be switched between high and low level with +24 dBu or +18 dBu @ 0
dBFS. The signal level can be switched for output pairs 1+2 and 3+4 individually.
X
Go to MENU → SETTINGS → AUDIO OUTPUTS:
+24 dBu results in slightly better signal-to-noise but may be too hot for some equipment. When
directly connecting your (active) studio loudspeakers, the lower signal level +18 dBu may be
useful to prevent ear blasting SPLs. If needed, you can dial in additional signal attenuation.
Speakers A/B latch mode
When using two sets of speakers, you may want to avoid both speaker pairs playing at the
same.
X
Go to MENU → SETTINGS → MONITORING and scroll down to the bottom of the page:
X
Activate “MIX 1-2 IN A/B MODE”.
Now you can easily toggle between both speaker pairs. Pressing the SPEAKERS A button
automatically mutes SPEAKERS B and vice versa.
To Next Page
