4VAL Operating & Maintenance Manual Version 1.1 © Newman Labelling Systems Ltd Page 10 of 56
SECTION 2 GENERAL DESCRIPTION
2.1 SAFETY
IMPORTANT
The machine is supplied with all guarding and other Safety Features necessary for
safe operation. If any modifications are made without the prior agreement of
Newman Labelling Systems Ltd. the warranty and Certificate of Conformity will
be void.
The intended use of this machine is to apply pressure sensitive self-adhesive labels
to containers. Use of the machine for any other purpose or use of components,
procedures, etc. not in this manual can result in a hazardous situation.
Newman Labelling Systems cannot be held responsible for any loss or damage to
product, machinery or personnel caused by misuse of the equipment or
unauthorized modifications.
Mechanical: Hazards on the machine are where practicable covered by fixed guards.
These must be maintained in the best condition to ensure no hazard is introduced. All
Fixed Guards, i.e. screwed or bolted panels and covers, should be secure before the
machine is run. No guard or cover should be removed from the machine without proper
authorisation. It is strongly recommended that a suitably qualified and trained person on
the integrity of both fixed and moving guards carry out frequent periodic checks.
N.B. No attempt should be made to remove guards or carry out repairs unless
properly authorised.
Electrical: The mechanically Interlocked Isolator on the control panel protects all mains
voltages on the machine. The machine meets IP54 for all panels and devices. Only
qualified personnel with technical knowledge or sufficient experience should be allowed
to work on the electrical systems of the machine. The machine should be isolated and
locked off before working on mains panel.
N.B. No attempt should be made to carry out repairs, unless properly authorised.
To Next Page
Loading...