Newtec EL470 - Page 81

Modem Reference Manual for EL470 IP Satellite Modem
Command
MoFrameType
DVB-S2 FEC-Frame
type
FEC-Frame type
Location /Modem/Control/Modulation/Main
Used as
variable of
Command(s)
IfStrConfig
Page
79
Only valid for DVB-S2 modes and XPE modes.
Description
Configuration of the DVB-S2 FEC-frame type. Two FEC-frame types are
defined:
• Normal FEC-frames of 64800 bits or 8100 bytes.
• Short FEC-frames of 16200 bits or 2025 bytes.This command
configures if short or normal length frames need to be created by the
encapsulator.Remark: Short frames introduce more overhead but
give a shorter encapsulation delay. Short frames are 4 times shorter
then normal frames.
RMCP
Command
ACF Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoFrameType
OID 1.3.6.1.4.1.5835.3.1.3.1.69.1.1
Values Factory Default
short
Enumeration Value
Short
Normal
0
1
Command
MoInpRate
Interface bitrate Interface bitrate
Location /Modem/Control/Modulation/Main
Not applicable for Air (TS) (multistream) processing mode.
Description
Configuration of the interface bitrate. This command configures the
(de)modulator input bitrate at the baseband interface. The actual range
depends on the installed hardware and software capability of the device.
RMCP
Command
TRr Access Normal user : RW
Expert user : RW
SNMP Table ntcDevsMod01ModulatorEntry
Command ntcDevsMod01MoInpRate
OID 1.3.6.1.4.1.5835.3.1.3.1.14.1.1
Values GUI Unit
Mbps
Cmd Unit Factory Default (CU)
bps 8.294.118
Expert Range (CU)
55000 .. 110000000
version 3.1
74
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS