5.8 Make a Test Print
The printer is ready for your first print! XiP comes preloaded with a test part file to get you started.
1.
Tap Continue if you want to select a preloaded model to start your first print.
Otherwise, tap Skip to create your first print later.
2.
Make sure the printer door is closed, then follow the instructions on the screen to
select a model and start your print.
3.
The screen continuously displays the status of your print.
4.
When the print is complete, let the build sit for 5 - 10 minutes to allow excess
uncured resin to drip back into the vat.
5.
Wear your goggles and gloves and open the printer door. Unlock the build plate by
flipping the lever down and remove the build plate with the part attached.
Your guided setup is complete! To re-run the guided setup, select
Settings > System > Onboarding
.
To Next Page
Loading...