EXCEPT FOR THE WARRANTY SET FORTH HEREIN, NEXA3D AND ITS LICENSORS AND SUPPLIERS
MAKE NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, OR STATUTORY, REGARDING OR
RELATING TO THE HARDWARE OR THE PRODUCT. NEXA3D AND ITS LICENSORS AND SUPPLIERS
SPECIFICALLY DISCLAIM ALL IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A
PARTICULAR PURPOSE, TITLE, AND NON-INFRINGEMENT WITH RESPECT TO THE HARDWARE AND
THE PRODUCT AND WITH RESPECT TO THE USE OF ANY OF THE FOREGOING.
9.1 Certifications
9.1.1 Radio and
Television
Interference
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a commercial
environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
⁃ Reorient or relocate the receiving antenna.
⁃ Increase the separation between the equipment and receiver.
⁃ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
⁃ Consult the dealer or an experienced radio/TV technician for help.
Contains FCC certified transmitter module(s):
⁃
2ABCB-RPI4B
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference
that might cause undesired operation.
To Previous Page
Loading...