7.2.5 Replace
the
Glass
LCD
Protector
The LCD screen is covered by a glass screen protector to shield the LCD from
damage. The screen protector will need to be replaced if it is cracked or scratched, as it
can puncture the membrane. A replacement kit can be purchased from our online
store, and it includes:
⁃ A replacement glass LCD cover
⁃
Cover removal tool
⁃ Dust-removal Stickers
⁃
Microfiber cloth
⁃
Alcohol-
wipe
The plastic spatula included in the finish kit will also be needed, as well as some sticky tape.
Make sure that the printer is in a dust-free environment for the easiest application.
Removing Cracked LCD cover
1.
Power down the printer and open up the door.
2.
Remove build plate, resin cartridge, and resin vat from the printer
to expose the LCD.
3.
Gently peel up the corners of the cracked cover using the flat edge
of the cover removal tool.
4.
Once corners are pulled up, peel cracked cover away from the LCD,
being careful not to touch the LCD glass surface.
5.
Wipe LCD screen with alcohol wipe and microfiber cloth to remove
as much residue and dust from the LCD glass surface as possible.
6.
Make sure that there is no dust on the LCD. Remove any visible
specks with the dust-removal stickers.
Applying Replacement LCD Cover
1.
There should be a protective film with a pull tab on each side of the
replacement cover. Only remove the protective films when specified.
2.
Lay the replacement cover down on a clean, dust-free work surface.
3.
Using the pull tab, gently peel away the bottom protective film.
4.
Handling the cover only by the edges, hold the cover over the LCD
and match up the corners so that they are aligned.
5.
Gently squeeze to slightly arch the cover toward the LCD and lower
until the middle of the cover rests on the LCD glass.
To Next Page
Loading...