6.
Slowly lower and let go of the edges of the cover until it settles
entirely onto the LCD.
7.
Using the straight edge of the plastic scraper from the finish kit,
gently scrape out any air bubbles that may remain beneath the cover.
8.
Using the pull tab, carefully peel the upward-facing protective film
away from the cover.
8. Basic
Troubleshooting
Problem
Possible
Cause
Corrective
Action
No display appears on the touchscreen
Check that the power cable is
connected to an AC source
Model does not stick to the build plate
Drag forces from model orientation is
pulling the part from the build plate
Ensure that there are no cups being
created by orientation, and that the
part is properly supported
Build plate leveling is not set well, causing the
first layer to have uneven thickness
Run through the Build Plate
Leveling process
Model does not have enough contact
between the bottom layer and Build Plate
Re-orient the model or
add more support
Ambient temperature is too cold
Make sure ambient temperature is
at least 70˚F / 20˚C
Resin has settled and needs mixing
Shake the resin cartridge for 30
seconds before installing
For more troubleshooting guidelines, visit support.nexa3d.com or
reach out to support@nexa3d.com to open a support case.
To Next Page
Loading...