2. Safety Alerts
Read
and
understand
this
manual
and
safety
alerts
prior
to
using
the
XiP
printer
DANGER
from
Nexa3D.
Failure
to
do
so
can
result
in
serious
injury
or
death.
CAUTION
CAUTION
Use appropriate protective equipment when handling resin and solvents, including cut & abrasion resistant gloves,
safety goggles, smock, and vapor respirator if recommended by SDS of resin or solvent.
The light engine used in LSPc emits 405nm visible light, which lies adjacent to the UVA band, UVA can damage eyes
with prolonged exposure. Use protective glasses rated for 99.9% UVA protection when working around the light
engine or post-cure equipment with covers removed.
Moving parts. Keep body parts away from moving parts.
CAUTION
CAUTION
WARNING
WARNING
NOTE
Only Nexa3D approved resins, membranes, and accessories (filters, resin system, etc.) should be used with XiP
to prevent risk of spill, equipment damage, or injury.
It is the user’s responsibility to verify suitability of material and process for application requirements. In no case shall
Nexa3D be liable for loss, death, or injury caused by products produced on Nexa3D printers or with Nexa3D materials.
Nexa3D expressly disclaims any implied or explicit warranty of fitness for any particular usage.
Immediately clean spilled resin from the printer, or it may cure and cause surface damage when removed.
Surfaces may be cleaned with IPA or xClean.
Resin Storage: Resin polymerizes when exposed to UV light sources, including sunlight. Store resin in original
containers and in a cool, dark location away from sunlight.
To Next Page
Loading...