The Membrane is a consumable part and becomes worn over time. Replace the
Membrane when wear begins to affect print quality. You should immediately replace the
Membrane if there is any visible damage or evidence of resin leakage.
1.
Tap
Settings > Printer Status
and then tap on the resin vat icon to unlock the
magnetic clamps that hold the vat onto the LCD.
2.
Lift off the resin vat.
3.
Clean the vat thoroughly to avoid dripping resin when the vat is turned over.
4.
Flip the vat over and place it on a clean, flat surface.
5.
Unlatch the 4 latches holding the Membrane onto the frame and lift off
the Membrane.
6.
Hold the new membrane by the edges and place it in the recess (screws facing
up), taking care not to touch the clear membrane.
7.
Make sure the Membrane is seated snugly on the face seal to prevent leaks
and close all 4 latches that hold the Membrane onto the frame.
8.
Turn the resin vat right side up and then place the vat back onto the LCD.
Note: Membrane Handling Precautions.
•
Handle by the frame only, avoid touching the Membrane.
•
Keep resin off light-engine side of membrane.
•
Avoid contact with any surface other than the light engine - keep on a clean
surface or in a clean bag.
•
If changing to a different resin, clean the resin side only using a lint free wipe
moistened with IPA.
•
Shelf life of new Membrane is 2 years stored in sealed bag.
•
Shelf life with resin is 2-4 weeks, store in a dark, clean container.
To
prevent
damage
to
the
membrane:
•
Check Build Plate for cured resin or burrs before use.
•
Filter resin or run a Clean job after any failed build.
•
Keep away from sharp objects.
•
Inspect
light
engine
surfaces
and
seals
for
cracks,
burrs,
or
damage.
•
Clean light engine surface with 99% IPA before installing membrane.
To Next Page
Loading...