Nexcom NEX 605 - I;O Interface Details; Watchdog Timer

Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved
3
Chapter 1: Product Introduction
NEX 605 User Manual
I/O Interface
• Serial port: 4 ports
• COM1, RS232 by DB-9 male on edge I/O
• COM2, 3, 4 support 3x RS232 ports by 2x 5-pins box header and dual-
JST 10pins wafer
• 8x USB 2.0: used 9 of 14 ports (ICH10R)
• 4x ports by 2x dual stack USB2.0 on edge I/O (port 0~ 3)
• 4x ports by 2x 5-pins header pitch 2.54mm (port 6~ 9)
• 1x ports to mini-PCIe slots (port 10)
• Power LED and HDD Active LED/ Reset/ Power On-Off by 2x 5-pins
header
• 2x 4-pins fan connector (for CPU and system)
• On board Buzzer and SMBus 2.0 by 1x 4-pins, IrDA by 1x 5-pins header
• 2x 13-pins box header for legacy parallel port/ LPT
• 2x 13-pins header for 6SATA/ 2GbE LEDs connector
Edge I/O Interface
• 1x dual stack PS2 for Keyboard/ Mouse
• 1x dual stack DB9 male for COM1 + DB15 female VGA
• 1x HDMI connector
• 1x dual stack eSATA (port 1 is default by eSATA)
• 2x RJ45 LAN + dual stack USB connectors
• 1x Mic-in/ 1x Speaker-out Jack
Watchdog Timer
• Watchdog timeout can be programmed by software from 1 second to
255 seconds and from 1 minute to 255 minutes (Tolerance 15% under
room temperature 25°C).
• Storage
• Default by 2x eSATA by external edge I/O and internal 4x SATA
connectors support RAID
• Optional by DIP-SW1 setting to 1x eSATA (on bottom edge I/O) and
internal 5x SATA
• 2x 13-pins header for 6x SATA/ 2x LAN LEDs connector
System Monitor
• Monitoring of 4 voltages and 2 temperatures
• 4 Voltage (Vcore, +12V , +3.3V , 5V)
• 2 Temperatures (CPU, System)
• 2 Fans Speed detection
On-board RTC
• On-chip RTC with battery backup
• 1x External Li-Ion battery
Power Input
• Support AT and ATX mode
Power Requirements
• Power requirement: ATX Input, jumper AT/ ATX (default) mode
• Onboard 2x 12-pins standard ATX version 2.0 power connector