Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved
36
Chapter 3: System Setup
NEX 605 User Manual
SATA Conguration
This section is used to configure the SATA drives.
SATA Mode
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Stor-
age configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the
storage driver to enable the advanced Serial ATA features
which will increase storage performance.
USB Conguration
This section is used to configure the USB.
Legacy USB Support
Enable Enables Legacy USB.
Auto
Disables support for Legacy when no USB devices are connected.
Disable Keeps USB devices available only for EFI applications.
USB3.0 Support
Enables or disables USB3.0 support.
XHCI Hand-off
This is a workaround for OSs that does not support XHCI hand-off. The
XHCI ownership change should be claimed by the XHCI driver.
To Next Page
Loading...
