Next Matrix Live - Function Keys in SCENE Mode

4.2 FUNCTION KEYS IN SCENE MODE
GB
In
SSCCEENNEE
mode there are 6
ffuunnccttiioonn kkeeyyss
see ( Pic. 2 par
44..11
).
COPY Key:
Press this key to copy the active scene on a free scene of the same program: the display shows
""SSEELLEECCTT DDEESSTTIINNAATTIIOONN SSCCEENNEE,,""
select through the 1÷12 keys the destination of the copy.
For the successive scenes use
PPAAGGEE
key
NNoottee
: After have pressed
CCOOPPYY
key, the same becomes
GGRRAABB
key.
GRAB Key: active only pressing COPY key
Press this key to store, the scene; you can then paste it in an empty scene of the same program
or in a diferent program. The key becomes
PPAASSTTEE
.
ALL Key: active only pressing COPY key
Press this key to copy all the scenes of the active program to another program: the display shows
""SSEELLEECCTT DDEESSTTIINNAATTIIOONN PPRROOGGRRAAMM,,""
select through the 1÷12 keys the destination of the copy.
For the successive program use
PPAAGGEE
key
PASTE Key: active only pressing in empty scene
Pressing this key the scene previously stored could be pasted to an any empty scene of any pro-
gram.
ERASE Key:
Press this key to the erase active scene, select through the 1÷12 keys (for the successive scenes
use
PPAAGGEE
key) the scene that must be erased, then press the
EERRAASSEE
key.
The scene will erased in a permanent way, it is not possible recover it.
TIME Key:
Press this key to change the total time of the scene, the value is in seconds from 1 to 600, use
the fader under the
TTIIMMEE
writing, or the encoder. To confirm the modify press the
OOKK
key, to get
out of the function press the
EESSCC
key.
CROSS Key: active only pressing TIME key
Press this key to modify the time of transition of the
scene, the value is express in percent from 0 to 100%,
use the fader under the
CCRROOSSSS
writing, or the encoder.
To confirm the modify press the
OOKK
key, to get out of
the function press the
EESSCC
key.
TO ALL Key: active only pressing TIME key
Press this key to set equal values for all the scene .
LAST Key:
Press this key to select the last scene of the program,
select through the 1÷12 keys (for the successive scenes
use
PPAAGGEE
key) the scene where you want to terminate the program, then press the
LLAASSTT
key.
For the successive scenes use
PPAAGGEE
key
NNoottee
: The last scene of the program will be stored automatically in
EEDDIITT
mode.
EDIT Key:
Press this key to create/modify the active scene see par. 4.3 EDIT IN SCENE mode
EFFECT Key :
Press this key to set a shape genarator for the active scene, for creation of an effect see par 7.5
EDIT EFFECT mode.
SCENE
Value
SCENE
CROSS
TIME