Nibe F1245 - Setting Time and Date

22 Checking the measurement values from
sensor
VWDUW JXLGH 
&KHFN ZKHWKHU WKH IROORZLQJ H[WHUQDOO\ LQVWDOOHG
VHQVRUV DUH ZLWKLQ WKHLU SHUPLWWHG YDOXHV
RXWGRRU WHPS(%%7
H[WHUQDO IORZ WHPS(%%7
ERLOHU VHQVRU(0%7
SRRO WHPSHUDWXUH(3[%7
KHDW PHGLXP IORZ(3%7
Check here whether the selected externally mounted
sensor shows permitted values for the installation.
23 Setting time and date
VWDUW JXLGH 
WLPH
GD\
\HDU
PRQWK
 KUV
 K
GDWH
Set time and date and display mode here.
24 Setting min. flow line temp.
VWDUW JXLGH 
FOLPDWH V\VWHP 
FOLPDWH V\VWHP 
FOLPDWH V\VWHP 
FOLPDWH V\VWHP 
r&
r&
r&
r&
PLQ IORZ OLQH WHPS 
climate system
Setting range: 15-50 °C
Default values: 15°C
Set the minimum temperature on the supply temperature
to the climate system. This means that F1245 never cal-
culates a temperature lower than that set here.
If there is more than one climate system the setting can
be made separately for each system.
TIP
The value can be increased if you have, for ex-
ample, a cellar that you always want to heat,
even in summer.
You may also need to increase the value in "stop
heating" menu 4.9.2 "auto mode setting".
NIBE™ F1245Chapter 6 | Commissioning and adjusting36