Nibe F1245 - Item Register

Item register
A
Accessibility, electrical connection, 18
Accessories, 75
Assembly, 5
B
Back button, 42
Brine side, 13
C
Cable lock, 19
Commissioning and adjusting, 27
Filling and venting, 27
Post adjustment and bleeding, 39
Preparations, 27
Start guide, 28
Connecting accessories, 26
Connecting current sensors, 23
Connecting external operating voltage for the control system, 20
Connecting the climate system, 14
Connecting the hot water heater, 14
Connections, 19
Contact for activation of fan speed, 25
Contact for activation of “external adjustment", 24
Contact for activation of “temporary lux", 24
Contact information, 4
Control, 42, 46
Control - Introduction, 42
Control - Menus, 46
Control - Introduction, 42
Display unit, 42
Menu system, 43
Control knob, 42
Controlling ground water pump, 25
Control - Menus, 46
Menu 1 - INDOOR CLIMATE, 46
Menu 2 - HOT WATER, 53
Menu 3 - INFO, 55
Menu 4 - HEAT PUMP, 56
Menu 5 - SERVICE, 60
Cooling mode indication, 25
Cooling section, 11
D
Delivery and handling, 5
Assembly, 5
Drawing out the cooling module, 5
Installation area, 5
Removing parts of the insulation, 7
Removing the covers, 6
Supplied components, 6
Transport, 5
Dimensions and pipe connections, 13
Dimensions and setting-out coordinates, 76
Display, 42
Display unit, 42
Back button, 42
Control knob, 42
Display, 42
OK button, 42
Status lamp, 42
Switch, 42
Disturbances in comfort, 73
Manage alarm, 73
Troubleshooting, 73
Docking alternatives, 15
Extra electric hot water heater, 15
Free cooling, 15
Ground water system, 16
Neutralization vessel, 15
Pool, 16
Two or more climate systems, 16
Under floor heating systems, 16
Ventilation recovery, 15
Draining the climate system, 67
Draining the hot water heater, 67
Drawing out the cooling module, 5, 69
E
Electrical addition - maximum output, 21
Setting of electrical steps, 21
Electrical cabinets, 9
Electrical connections, 17
Accessibility, electrical connection, 18
Cable lock, 19
Connecting accessories, 26
Connecting external operating voltage for the control system, 20
Connections, 19
Electrical addition - maximum output, 21
External connection options, 24
General, 17
Load monitor, 23
Miniature circuit-breaker, 17
Motor cut-out, 17
Optional connections, 23
Outdoor sensor, 20
Power connection, 19
Removing the cover, base board, 18
Removing the cover, immersion heater circuit board, 18
Removing the hatch, input circuit board, 18
Room sensor, 21
Settings, 21
Standby mode, 22
Temperature limiter, 17
Temperature sensor, external flow line, 20
Emptying the brine system, 68
External connection options, 24
Contact for activation of fan speed, 25
Contact for activation of “external adjustment", 24
Contact for activation of “temporary lux", 24
Controlling ground water pump, 25
Cooling mode indication, 25
Extra circulation pump, 25
Hot water circulation, 25
Indication of buzzer alarms, 25
NV 10, pressure/level/flow monitor brine, 25
Switch for external blocking of addition and/or compressor, 24
Switch for external blocking of heating, 24
Switch for external forced control of brine pump, 24
Extra circulation pump, 25
F
Filling and venting, 27
Filling and venting the brine system, 27
Filling and venting the climate system, 27
Filling the hot water heater, 27
Symbol key, 28
Filling and venting the brine system, 27
Filling and venting the climate system, 27
Filling the hot water heater, 27
H
Heating medium side, 14
Connecting the climate system, 14
Helping the circulation pump to start, 68
Help menu, 45
Hot water circulation, 25
83Chapter 13 | Item registerNIBE™ F1245
13 Item register