Nibe F1345 Series - Start-up, Inspection, and Pump Adjustment

P
BK / JK
Stä
ngs
Collector
Closes
SYMBOL KEY
MeaningSymbol
Shut-off valve
Safety valve
Expansion vessel
Pressure gauge
P
Particle filter
Start-up and
inspection
START GUIDE
NOTE
There must be water in the climate system
before the switch is set to " ".
NOTE
With several heat pumps connected, the start
guide must first be run in the subordinate heat
pumps.
In the heat pumps that are not the main unit,
you can only make settings for each heat
pump’s circulation pumps. Other settings are
made and controlled by the main unit.
1.
Set switch (SF1) on F1345 to position "".
2.
Follow the instructions in the display’s start guide.
If the start guide does not start when you start the
F1345, start it manually in menu 5.7.
TIP
Refer to the operating manual for a more in-
depth introduction to the control system in
F1345 (operation, menus, etc.).
Commissioning
The first time the installation is started a start guide is
started. The start guide instructions state what needs
to carried out at the first start together with a run
through of the installation’s basic settings.
The start guide ensures that the start-up is carried out
correctly and, for this reason, cannot be skipped.
Caution
As long as the start guide is active, no function
in the installation will start automatically.
The start guide will appear at each restart of
the installation, until it is deselected on the last
page.
NIBE F1345Chapter 6 | Commissioning and adjusting36