Nibe F1345 Series - Accessories; Communication, Control, and Heating Accessories

Not all accessories are available on all markets.
ACCESSORY CARD AXC 50
An accessory board is required if, for example, a ground
water pump or external circulation pump is to be connected
to F1345 at the same time as the indication of common
alarm is activated.
Part no. 067 193
ACTIVE/PASSIVE COOLING IN 2-PIPE SYSTEM
HPAC 45
Combine F1345 with HPAC 45 for passive or active
cooling.
Intended for heat pumps with outputs 24 – 60 kW.
Part no. 067 446
ACTIVE/PASSIVE COOLING IN 4-PIPE SYSTEM
ACS 45
Part no 067 195
AUXILIARY RELAY HR 10
Auxiliary relay HR 10 is used to control external 1 to 3
phase loads such as oil burners, immersion heaters and
pumps.
Part no 067 309
BUFFER VESSEL UKV
UKV is an accumulator tank that is suitable for connection
to a heat pump or another external heat source, and can
have several different applications. It can also be used
during external control of the heating system.
UKV 300
Part no. 080 301
UKV 200
Part no. 080 300
UKV 500
Part no. 080 114
COMMUNICATIONS MODULE MODBUS 40
MODBUS 40 enables F1345 to be controlled and mon-
itored using a DUC (computer sub-centre) in the building.
Communication is then performed using MODBUS-RTU.
Part no 067 144
COMMUNICATIONS MODULE SMS 40
When there is no internet connection, you can use the
accessory SMS 40 to control F1345 via SMS.
Part no 067 073
CONNECTION BOX K11
Connection box with thermostat and overheating protec-
tion.
(When connecting Immersion heater IU)
Part no. 018 893
DOCKING KIT SOLAR 42
Solar 42 means that F1345 (together with VPAS) can be
connected to thermal solar heating.
Part no 067 153
DOMESTIC WATER EXCHANGER PLEX
310 - 40
Part no. 075 316
310 - 20
Part no. 075 315
310 - 80
Part no. 075 318
310 - 60
Part no. 075 317
322 - 40
Part no. 075 320
322 - 30
Part no. 075 319
322 - 60
Part no. 075 321
NIBE F1345Chapter 7 | Accessories42
7 Accessories